חמש בעיות נפוצות של מערכת קירור
ראשית, טיפול בקירור לא מספיק
1. תופעת כישלונות: השפעת הקירור של כל המכונה לקויה, שקע המים קר רק מעט, ונמצא כי הלחץ בצד הלחץ הגבוה - וצד הלחץ הנמוך - נמצא להיות נמוך עם מד לחץ סעפת (תחת המהירות הרגילה של המדחס, כאשר הטמפרטורה הסביבתית היא בערך 35 ℃, הלחץ הנמוך מדד המונים נמוך מ- 1 kg / cm2, מדד מד הלחץ הגבוה - נמוך יותר יותר מ- 10 ק"ג / ס"מ 2), וניתן לראות את זרימת הבועה מזכוכית הראייה.
2. The cause of the failure: the refrigeration system has a refrigerant leakage point, which results in insufficient refrigerant.
3. Treatment method: 1). Use electronic leak detector to find the leak point and repair or replace parts.
2). If the parts are not replaced, only the appropriate amount of refrigerant can be added; if the parts are replaced, the appropriate amount of refrigeration oil should be added as required, and the refrigerant should be added after the system is evacuated.
שנית, טעינת יתר של קירור
1. Failure phenomenon:
אפקט הקירור גרוע, והלחץ בצד הלחץ הגבוה - וצד הלחץ הנמוך - גבוה מדי כאשר נבדק עם מד לחץ סעפת (כאשר מהירות המדחס תקינה וטמפרטורת הסביבה) הוא 35 מעלות צלזיוס, לחץ מד לחץ - הגבוה הוא כ 19 ק"ג / ס"מ 2, ולחץ מד לחץ - הנמוך הוא 2.3 ק"ג / ס"מ 2, ולא ניתן לראות בועות אוויר בזכוכית הראייה .
2. Failure reason: Too much refrigerant is added in the refrigeration system, so that the refrigeration capacity cannot be fully exerted, resulting in poor refrigeration effect.
3. Treatment method: Connect the manifold pressure gauge to the system, and slowly loosen the manual valve on the low pressure side of the manifold pressure gauge, so that the refrigerant is slowly discharged (cannot be discharged from the high pressure side, because the refrigerant will be taken out from the high pressure side) A large amount of freezing oil) until the pressure on the high and low sides is normal, and the refrigerant flows clearly from the sight glass, and occasionally bubbles flow through.
שלישית, מערכת הקירור מעורבת באוויר
1. תופעת כישלון: כושר הקירור של כל המכונה מופחת; הלחץ בצד הלחץ הגבוה נמצא גבוה כאשר בודק מד לחץ סעפת, והלחץ בצד הלחץ הנמוך עשוי לפעמים להיות גבוה מהערך הרגיל (מהירות המדחס תקינה וטמפרטורת הסביבה היא 35 מעלות צלזיוס) נכון לעכשיו, הלחץ בצד הלחץ הגבוה - גבוה מ- 20 kg / cm2; המצביע של מד הלחץ הגבוה - מתנדנד; מצד שני ניתן לראות בועות רבות זורמות. מזכוכית הראייה.
2. Reasons for failure:
אוויר מעורב במערכת. בעיקר לאחר הרכבה או שיפוץ, הוואקום אינו יסודי; בעת טעינת נוזל הקירור או הוספת שמן קירור, האוויר מוחדר למערכת, או כאשר המערכת עובדת בלחץ שלילי, האוויר מעורבב במקומות הצפופים. לאחר כניסת הקירור לאוויר יש לו לחץ מסוים, וגם לקירור יש לחץ מסוים. במיכל סגור, לחץ הגז הכולל שווה לסכום הלחצים החלקיים, כך שקריאה של מד לחץ גבוה ונמוך גבוהה מהרגיל.
3. Treatment method: 1) Release refrigerant (release slowly from low pressure side with pressure gauge). 2) Check the cleanliness of the compressor oil. 3) Refill the refrigerant after vacuuming.
Fourth, & quot;ice blockage & quot; appears in the refrigeration system
1. Failure phenomenon: The refrigeration system periodically cools suddenly but not suddenly. During operation, the pointer on the low pressure side of the manifold pressure gauge often fluctuates between the negative pressure and the normal value.
2. Cause of failure: Moisture is mixed into the refrigerant in the refrigeration system. Because the water is incompatible with the refrigerant, when the refrigerant flows through the orifice of the expansion valve, the temperature drops suddenly. These are mixed in the refrigerant The water will easily form small particles of ice in the vicinity of the small hole of the throttle valve or around the valve pin hole, which is spherical or hemispherical. When the ice particles are condensed to a certain extent, the throttle channel is blocked and an ice jam fault is formed. . When ice blocking occurs due to icing, the refrigeration system cannot work properly, and the refrigeration effect is significantly reduced, even without refrigeration.
בשלב זה, מד הלחץ הנמוך נראה בלחץ שלילי, לכן ברור כי הטמפרטורה של גוש הקרח הועלתה, חלקיקי הקרח של גוש הקרח נמסו למים, כך שתופעת גוש הקרח נעלמה, מערכת הקירור חזרה לפעולה רגילה, הקירור היה טוב, ולחץ הצד הלחץ הנמוך חזר לקדמותו. כעבור זמן מה הייתה סתימת קרח במערכת והמערכת לא תקינה.
3. Treatment method: 1) Because the desiccant is in supersaturated state, it is necessary to replace the reservoir with desiccant and add 30ml of freezing oil. 2) Vacuum the system and add a specified amount of refrigerant.
פתרון בעיות סתימה חמישית ומלוכלכת
1. Failure phenomenon: poor cooling effect or no cooling. When the air conditioning system is running, the readings of the high and low pressure gauges on the manifold pressure gauge are less than the normal value. (When the compressor speed is normal and the ambient temperature is around 35 ° C, the pressure on the high pressure gauge side is less than 9 kg / cm2, and the pressure on the low pressure side is Negative pressure), and there is frost or dew on the filter and capillary tube.
2. The cause of the failure: the dust in the refrigeration system adheres or adheres to the filter screen at the inlet end of the filter, or the interface between the capillary and the filter screen, so that a local throttling phenomenon is formed at this location, and the temperature drops rapidly, and condensation or condensation occurs Frost.
3. Treatment method: If there is frosting at the filter inlet, and the sound of intermittent airflow is heard, tap the filter body with a small wrench, the airflow sound changes, and the frost layer of the filter and capillary melts at the same time, which can be judged The filter inlet filter is clogged.
בשלב זה: ① הסר את הנימי, נקה את המסנן ונשף יבש והתקן אותו מחדש. לחלופין, החלף את המסנן ② מפנה וממלא את הקירור לכמות שצוינה.











